For my original piece, the rectangular part did not print all the way and the dimensions were exactly the same as a base so it did not fit into the bottom of the base. I tried sanding it down but then I realized that it will not help since i will have to sand off a lot. So I decided to reprint the parts.

The cable and extruder of the Zolarix printer was broken so I had to revert back to using NVBots. 

I was able to print my rectangular parts and a pair of the cylinder rods due to the time constraint. The cylinder rod in the front were a bit to long and I realized I did not need them that long. Therefore, I used a small saw to cut the rod in half. Then I glued together the pieces using acrylic glue.