Back to Parent


Since this print of my planter was my first print, I would make sure to set aside ample time to have 2 or 3 prints to take out any kinks in the printing. For example, if I had additional time to print more, I would have fixed the issue with four out of five of my towers not printing. 

Another change I would make is to use the NVBOTS 3D printer instead of the Zortrax 3D printer, because all of the prints on the NVBOTS printers came out flat, and did not end up curling up.

Content Rating

Is this a good/useful/informative piece of content to include in the project? Have your say!