One of the largest challenges in the process was using Slicer. I tried several different Manufacturing settings for the slots that gave the model the interlocking design. When adjusting for 6mm and 3mm plywood thickness, I tried increasing and decreasing the Slot Offset but still could not get slots that fit together as they were made too small. The slots seemed to get smaller when the offset was set to be larger (which would make sense if the slot offset setting is made to account for kerf). I tried to increase the material thickness to make larger slots, but no progress was made. Eventually, I used 3mm plywood and Stacked for the Construction Technique to capture the most detail.