With the most time consuming phase behind me, I finally was able to start casting. I cut a pour hole at the top of the mold large enough to fit the spout of the funnel. After, I drilled air holes at the highest elevation of each tentacle to make sure that the resin would reach those areas. I wrapped rubber bands around the silicone mold so they would be held tightly together. I mixed Part A and Part B of the resin at a 1:1 ratio thoroughly and then poured at the top.
Content Rating
Is this a good/useful/informative piece of content to include in the project? Have your say!
You must login before you can post a comment. .