Back to Parent

Then I sliced my mold in half, to open it back up. I had a hard time finding the parting line between the two molds, which can be seen in the way certain parts of my mold were slightly detached or cut where they weren't supposed to be. However, other than that the silicon turned out alright. I then cut a pour hole into the half of the mold shown in the lower half of the picture above. Also pictured are two small holes that I cut later to get rid of air bubbles at the top of my mold. 


Content Rating

Is this a good/useful/informative piece of content to include in the project? Have your say!

0