The good news is that the grip detached from the block much easier. A small amount of cutting around edges was still required, but then the grip popped out.
However, this iteration showed that the "air holes" I had added after the past iteration were not nearly large enough. In addition, there were many more microbubbles in the resin, as I had not been able to degas the resin beforehand. The combination of the large bubble by the finger grip (notice: in the same place as last time) and the microbubbles made this part unusable.
Content Rating
Is this a good/useful/informative piece of content to include in the project? Have your say!
You must login before you can post a comment. .