Back to Parent

FUTURE ITERATIONS


The biggest challenge in this project was the limit on number of iterations, because of the cure time of each prototype. Thus, even after the completion of the project, there are things I wish I could have tried to make the molding process smoother.

Although it didn't happen in my last iteration, I could envision air holes forming along the outside edges of each indent. To remedy this, I would add more air holes along the edges of each of the palm grips.

In addition, using saran wrap could have made the removal of the wooden block even simpler. It may have added an unusual texture, but this would only have occurred on the inside of the block.


Content Rating

Is this a good/useful/informative piece of content to include in the project? Have your say!

0