Process

I went through a few different iterations before landing on this setup. Originally I was going to use the RGB LED to change the hue of the light with the potentiometer, but I could not get the RGB LED to set up properly following the instructions, so I will attempt that for next time. Next, I was going to use the temperature sensor to set the LED brightness to a corresponding level of heat (so low light for low temp, etc) however, the wiring diagram online must have had some errors because when I set it up following that it got hot and I immediately had to remove it. So I settled on something a bit different than where I started to still explore how these two components could interact. The next step would be to eliminate the potentiometer and have the user provide input on their device using a slider.