// Define a pin that we'll place the photo cell on
// Remember to add a 10K Ohm pull-down resistor too.
int photoCellPin = A0;

// Create a variable to hold the light reading
int photoCellReading = 0;

// Define a pin that we'll place the pot on
int potPin = A5;

// Create a variable to hold the pot reading
int potReading = 0;

// Define a pin we'll place an LED on
int ledPin = D2;

// Create a variable to store the LED brightness.
int ledBrightness = 0;


void setup()
{
  // Set up the LED for output
  pinMode(ledPin, OUTPUT);
  
  // Create a cloud variable of type integer
  // called 'light' mapped to photoCellReading
  Particle.variable("light", &photoCellReading, INT);
  Particle.variable("pot", potReading );
}

void loop()
{
  
  // Use analogRead to read the photo cell reading
  // This gives us a value from 0 to 4095
  photoCellReading = analogRead(photoCellPin);
  
  // Use analogRead to read the potentiometer reading
  // This gives us a value from 0 to 4095
  potReading = analogRead(potPin);
  ledBrightness = map(potReading, 0, 4095, 0, 255);


    if(photoCellReading < 2000){  //sensor was never less than 3000
        // fade the LED to the desired brightness
        analogWrite(ledPin, ledBrightness);
    } else{
        digitalWrite(ledPin, LOW);
    }
    
  // wait 1/10th of a second and then loop
  delay(100);
}