Next Steps:

One of the items that I would like to try that I did not get to was trying to see how I could potentially get two different sensors to work with one another. I would have liked to see if I could create a multi-sensor criteria where after more than one parameter was met then that would create a different output, maybe not on a LED light this time. 

Reflection:

One of the primary obstacles I encountered was understanding why I needed create the flexValue variable as that seemed like a gap in my understanding until I figured it out. After I figured this out, it became easier to understand how I would make this variable <>=, to the various flex sensor bend thresholds that I was creating. To add, the bend thresholds were a little tricky to dial in. To little or to much would allow it to be to easily triggered or not at all. If the interval between the two bend pressure measurements were not set wide enough either then you couldn't make it distinct enough between to two readings that I was trying to create.