IDeATe

Outcome

Move up Delete Move down

Intention

The intention is to explore how can we use particle build online console to control the argon board.

Move up Delete Move down

Process

During the process, I mainly change the loop() function to update the logic.

Move up Delete Move down

Ex. 1

Move up Delete Move down

int led1 = D3;

void setup() {
    
    pinMode(led1, OUTPUT);

}

// EX 1
void loop() {

    digitalWrite(led1, HIGH);
    delay(3000);
    digitalWrite(led1, LOW);
    delay(3000);
}

Show Advanced Options

Move up Delete Move down

Show Advanced Options

Move up Delete Move down

Ex. 2

Move up Delete Move down

int led1 = D3;

void setup() {
    
    pinMode(led1, OUTPUT);

}


// EX 2
void loop() {
    
    for (int i = 0; i < 5; i++) {
        digitalWrite(led1, HIGH);
        delay(500);
        digitalWrite(led1, LOW);
        delay(500);
    }
    
    delay(3000);

}

Show Advanced Options

Move up Delete Move down

Show Advanced Options

Move up Delete Move down

Ex. 3

Move up Delete Move down

EX3 requires us to add another LED as an output. I was not sure if a small transparent component is an LED (I believe it is not). Also, I spend sometime to figure out how could I connect the two LED in parallel (instead of in sequence).

Move up Delete Move down


int led1 = D3;
int led2 = D2;

void setup() {
    
    pinMode(led1, OUTPUT);
    pinMode(led2, OUTPUT);

}


// EX 3
void loop() {

    digitalWrite(led1, HIGH);
    digitalWrite(led2, LOW);
    delay(3000);
    digitalWrite(led1, LOW);
    digitalWrite(led2, HIGH);
    delay(3000);

}

Show Advanced Options