Multi-functional Phone Holder | Project

PHONE HOLDER MADE IN THE PAST

This is a phone holder that I made in the past to help support my phone at an designated angel while my hands are busy working on something else. It is cheap and fast in making, but its function is limited. It is also limited to using the phone horizontally.

SOLUTION APPROACH

The goal is to use CNC processing to prototype a phone holder that is affordable to everyone and easy to carry around. It should be multi-functional: phone holder, speaker/ sound distributor, and pen holder.

Its main body is made of 3D printed plastic and the side holders are laser-cut clear acrylic. The main body includes a speaker to create interesting sound effect for music playing.

As shown in the image below, its main body and the horizontal supports on the side are connect by a hinge. It is a section of the vertical phone holder part with the speaker/ sound distributor.

The image below is the pen holder part. It not only serves as a second function but also adds weight to the plastic holder that the phone will not make it fall over.

Expectation

Ideally, the holder is able to be placed on any horizontal surface due to its small size.

Fabrication Process

The image below shows its simple assembling process.

Final Result

The final prototype turns out neatly. It is very close to the expected result. The challenge would be fitting the hinge into the 3D printed part, since NVBots is not very precise. However, all of its designated functions works. The weakness is that the angle of horizontal supporter is fixed. In the next prototype, I would redesign the hinge so that the phone could be held in different angles.

Start the Conversation

Share this Project

This project is only listed in this pool. Be considerate and think twice before sharing.

About

The goal is to create a multi-functional phone holder -- speaker and pen holder. The phone holder allows a phone to be viewed both vertically and horizontally. The vertical setting includes a sound distributor/speaker to assist music playing. The pen holding part not only adds use to the project but also increase weight to stabilize. Its main body is made of 3D printed plastic and the sides are laser-cut acrylic. The material choice makes it affordable by everyone and easy to carry around.