Project 2

Made by Rachel Wong

This project is meant to show our ability to successfully create and print a STL design.

Created: October 16th, 2017



The goals of this project are to prepare a 3D file, export a valid mesh, and successfully print our design. 



Our guidelines were to make a general holder/container. I decided to make a cylindrical cup to hold my makeup brushes because they are often scattered all over my room. 



My process was basically all in fusion 360. I started by measuring my cylinder with the guidelines that the whole thing had to be larger than 2 cubic inches. I then created a downwards hole from the top of the surface. 

I then exported it to a 3d printable mesh. 

Finally, I uploaded it to NVbots and waited for it to get approved.