Resin Laptop Stand

I had seen pictures and videos in the past of people making resin inlaid tables, and I've wanted to try making something similar for a while. I have always liked natural scenes and water, and thus my mood board has a lot of those types of images, in addition to some examples of resin tables.

The intended user for this product would be someone who is very busy, presumably a student or office worker, who doesn't ever seem to find the time to clean off their desk. As a result, they never have room on their desk for anything. This was inspired by my own messy desk, where I needed to clear off a lot of stuff, including my computer in order to have space to work on sketches.

Process

My initial concept included a built-in monitor stand, however, I realized that this would be very large, and make it more of a niche item for people who have laptops with second monitors.

My final concept was just the laptop stand, with a writing surface that could pull out.

Building the resin surface

I began by cutting out the piece of oak that would become the top surface for the stand. I then traced a cutout that followed the grain of the wood and then cut along the lines that I traced.

I then built a mold using some acrylic left over from my first project, and attached it to the wood using hot glue.

I then poured my first layer of resin mixed with glitter. I found out that mixing the glitter and both parts of the resin at the same time caused many small bubbles to form in the surface. Thankfully, most of these settled out by the time it cured.

I then poured the second layer of resin. For this layer, I mixed the resin and then mixed in the glitter just before pouring it to minimize the number of bubbles. The image above is cloudy due to the number of bubbles, while the one below isn't.

I then removed the mold. The surface tension of the resin caused a ridge to form near the edges, so I ground this off.

I then brushed on a thin layer of resin to give the whole surface a gloss look. I had originally intended to only stain the wood, but I realized that this would require sanding the resin inlay, and I did not have any polishing equipment to remove the scratches from sanding.